
MOLDS & RELEASE AGENTS
Polyklear Fiberglass + Resin offers a broad variation of mold and release agents to provide an easier fabrication process at the same time keep the finished output within acceptable quality.
Molds & Release Agents

POLYKLEAR MOLD RELEASE WAX LIQUID
Polyklear Mold Release Wax Liquid is a petroleum-based mixed waxes intended for mold release and lubrication. This can be applied on mold surface either by brush or wiping with rag.
Properties
Soft yellowish paste
Applications
Mold release agent

POLYKLEAR TOOLING GELCOAT
Polyklear Tooling Gelcoat is non-sagging, pre-accelerated polyester resin specially applied on the FRP mold outer surface. It is very durable thereby providing excellent surface protection for the product.
Add With:
Polyklear Butanox M-50 or Polyklear Butanox M-60 at 1.5-2.5 %
Properties
Excellent in water resistance
Good weathering property
UV resistant
High chemical resistance
Excellent mechanical strength
Applications
Outer or surface skin of FRP molds

THAILAND GYPSUM PLASTER OF PARIS
A fine, white, quick-setting powder that hardens when moistened and allowed to dry. Plaster of Paris from Polyklear is an ideal material for casting molds because it generally does not shrink or crack when dry. Recommended mixing ratio to water is 1:2 by volume
Properties
Quick-setting
Minimal shrinkage
Fire resistant
Applications
Molding and casting agent Statues and monuments

TR-102 MOLD RELEASE PASTE WAX
TR-102 Mold Release paste wax 14OZ from Polyklear is a an excellent paste release with good breakdown for fast, even coverage. Formulated for fast drying with a high content of carnauba wax. One application of this on mold surface is good for a maximum of eight number of pulls mold can be used up to 8 times before reapplication of wax.
Properties
Extremely easy to apply and wipe off.
Fast drying
Produces smooth, mirror finishes
Applications
Mold release agent

TR-111 SLURRY RELEASE WAX
TR-111 Slurry wax release is a soft white refined petroleum- based wax. Slurry wax leaves no discoloration to molded parts. Reapplication is necessary every pull mold can only be used once and would need another application for next part to be molded. This mold-release agent is suited for parts where gloss and cosmetic surface is not a critical requirement.
Properties
Easy spreading and wipe characteristics
Provides better release output
Applications
Mold release agent